DEPRAG – For fully automated and efficient production
Manual workstation for assembly of oil pumps
Mandatory process:
Reliable manual process workstation for 2 operators for the assembly of oil pumps for combustion engines
Workstation 1:
- The individual parts are loaded into the parts fixture.
- Manual piston and spring assembly
- Insertion and tightening of locking screw
- Fitting of sleeves, shaft and cover
- Tightening of the pump housing with an EC-Screwdriver .
A Control Stand Position of each set of bolts - Assembly of bevel gears
- Screw the toothed gears to the shaft with an EC-Screwdriver
- Pump casing marking (punch marking)
- Only when all parts are present and the screwdriver sequence has been followed will the parts locking device release the assembly.
- Removal of the pre-assembled part
Workstation 2:
- Pre-assembled part loading
- Assembly of the gear assemblies and cover (A)
- Adjusting the cover (A) with the pump casing
A Position Control Stand for each set of screws. </ Li > - Insert the center bushings, the filter plate and the cover (B).
- Presence control of the filter film
- Mounting the cover (B) with the pump casing.
A Control Stand Position of each set of screws - Pump casing marking (punch marking)
- Only when all parts are present and the screwdriver sequence has been followed will the part attachment release the finished oil pump.
- Operator unloading of oil pump
The workstation base is height adjustable and can be changed to suit the height of each individual operator using a remote control.
